Price: ₹10,000 - ₹9,000.00
(as of May 03, 2025 05:10:59 UTC – Details)
Product Description
Support for two subwoofers
This amplifier is powerful enough to support upto two single coil 12 inch subwoofers rated around 300-400 watts nominal and impedance 4-8 ohms.*
This amplifier can also be used as a power amplifier to attach towers speakers in case your AVR does not have enough power for the heavy tower speakers.
*If using dual coil subwoofers, use only one coil from each subwoofer.
Power amplifier mode
Pressing the direct mode button converts this subwoofer amplifier into a power amplifier. In power amplifier mode this can be used to power big tower speakers taking signal from the AVR or DSP.
Balance control
This amplifier can support subwoofers of different sizes and different ratings.
Using the balance control knob power can be increased or decreased from one side to another.
A smaller subwoofer can play at lesser volume and power while a larger subwoofer can be played louder at higher volume using the balance knob.
Speaker protection
The amplifier contains a stereo speaker protection module with big relays to prevent any direct current gong to the subwoofers or the speakers.
In case there is any malfunction, the amplifier will cut sending power to the subwoofers which will prevent any harm to your expensive subwoofers or speakers.
This also prevent jerks at the time of power on and off. So the amplifier is complete;y silent when you switch it on or off even when the gain is at your desired level. You do not need to adjust the gain again and again while switching the amplifier on and off.
Active cooling
This amplifier has active cooling with not just one but three cooling fans.
Slow speed low noise cooling fans keep the heat out of the amplifier and keeps it cool increasing the long life of this amplifier.
Double Channel amplifier with 200 Watts RMS per channel nominal output and 300 Watts RMS per channel peak output . Separate active low pass filter for left and right channels with soft start and speaker protection relay circuit. Heavier heat sink
MOSFET/BJT based with pure copper transformer for improved sound quality and power handling. Please keep the amplifier switched off while connecting speaker wires to prevent damage.
Direct mode deactivates low pass filter and amplifier can be used as power amplifier. Use direct mode when using with AVRs or Sound Processors
Inputs: 1xRCA. Line out through RCA to connect with other audio devices like any other amplifiers.
Support for 2 subwoofers rated upto 300-400 Watts RMS, single coil subwoofers, Woofer Size: 12 inches, Frequency Response: 10Hz to 150Hz, Impedance: 4-8 Ohms, Dimensions – WxDxH = 37x28x11 cm